Audi Workshop Service and Repair Manuals > A4 Mk1 > Body | General Body Assembly, Interior (Repair groups 68, 69, 70, 72, 74) | Trim, noise insulation | Trims, Avant | Removing and installing fastening ring (Avant)

General Body Assembly, Interior (Repair groups 68, 69, 70, 72, 74)

Trims, Avant

Removing and installing fastening ring (Avant)

‒ Unscrew both bolts for each fastening ring.
‒ Observe torque: 4.5 Nm.
‒ Remove luggage compartment floor covering.
‒ Remove side trim
‒ Remove underlay for luggage compartment floor covering and unscrew holders for front and rear fastening rings.



‒ Install in reverse sequence to removal. ‒ → Torques for front holder: ‒ Cross-head screw (2x for FWD; 4x for quattro): ‒ 6 Nm ‒ Hexagon bolt (1x for FWD only): ‒ 30 Nm



‒ → Torques for rear holder: ‒ Bolt in floor: ‒ 23 Nm ‒ Bolt in rear panel: ‒ 10 Nm

Audi Workshop Service and Repair Manuals