Audi Workshop Service and Repair Manuals

• ● Gearbox installed

Removing and installing speedometer sender -G22

• ‒ → Pull connector off sender -B-.
• ‒ Press sender retainer down, turn and pull out sender.
• ‒ Renew O-ring -A-.

Removing and installing drive wheel for speedometer sender -G22

Removing:

• ‒ Detach drive shaft from left flange shaft -B-.
• ‒ → Unscrew bolt -A-. Secure flange shaft with a drift to prevent it turning.
• ‒ Remove flange shaft and seal -C-.
• ‒ Remove drive wheel for speedometer sender -D- by alternately levering the retainer clips (arrows) with a screwdriver.

Installing:

• ‒ Fit drive wheel for speedometer sender with the retainer clips (arrows) facing the seal.

Note:

Do not tilt when installing (risk of breakage).

• ‒ Follower lugs engage in differential housing grooves.
• ‒ Renew seal for flange shaft and install flange shaft .
• ‒ Check oil level in gearbox => Page 34-39.