Audi Workshop Service and Repair Manuals

Note:

Removing and installing thrust tube

.

• Flange shaft
• ◆ Removing
• ◆ On installation, simultaneously insert circlip -Item 39-120
• Oil seal
• ◆ Prising out => Page 39-117
• ◆ Driving in => Page 39-119
• Circlip
• ◆ Removing => Page 39-117

• Grooved ball bearing for flange shaft
• ◆ Extracting => Page 39-118
• ◆ Pressing in
• Collar
• ◆ Removing => Page 39-115
• ◆ Pressing on => Page 39-120
• Baffle plate
• ◆ Only press out if damaged
• ◆ Installing => Page 39-118
• Circlip
• ◆ Splaying circuit to remove flange shaft => Page 39-116
• O-ring
• ◆ Replace
• Bolt, 35 Nm
• ◆ For attaching thrust tube to housing of rear final drive

• Thrust tube
• Bolt, 40 Nm
• ◆ For attaching gearbox support to thrust tube
• Gearbox support
• Circlip
• ◆ Removing => Page 39-115
• Cap
• ◆ Removing => Page 39-115
• O-ring
• ◆ Replace