Audi Workshop Service and Repair Manuals

• ● Gearbox fitted

Removing and installing speedometer sender -G22

• ‒ → Unplug connector of sender -B-.
• ‒ Press down retainer of sender, twist and take out sender.
• ‒ Replace O-ring -A-.

Removing and installing drive wheel for speedometer sender -G22

Removing:

• ‒ Unscrew drive shaft from left flange shaft -B-.
• ‒ → Screw out bolt -A-, holding flange shaft in position with mandrel to stop it turning.
• ‒ Remove flange shaft and oil seal -C-.

• ‒ → Apply screwdriver alternately to drive pins -arrows- and prise out drive wheel for speedometer sender -D-.

Installing:

• ‒ Insert drive wheel for speedometer sender such that drive pins -arrows- are facing oil seal.

Note:

Attach drive wheel carefully to differential, taking care to keep it straight. Do not use force as this could cause drive wheel to break off.

• ‒ Engage drive pins in grooves of differential housing.
• ‒ Replace oil seal for flange shaft and install flange shaft .
• ‒ Install flange shaft.
• ‒ Attach drive shaft to flange shaft.

=> Running Gear, Front-wheel Drive and Four-wheel Drive; Repair Group 40; Removing and installing drive shaft

• ‒ Top up gear oil in manual gearbox and check oil level => Page 34-143.