Audi Workshop Service and Repair Manuals

=> Overview, Page 37-97

Note:

Assembling planetary gearbox

.

• Reverse gear clutch -K2-
• ◆ When installing, rotate clutch until all the inner plates have meshed
• ◆ Dismantling and assembling
  

• Shim
• ◆ Determining thickness
  => Adjusting clutch play between -K1- and -K2-, Page 37-149
• ◆ Up to 3 shims may be installed
• 1st to 3rd gear clutch -K1-
• ◆ On some gearboxes the clutches -K1- and -K3- may be pressed together
• ◆ Pressing -K1- onto -K3- => Page 37-130
• ◆ Dismantling and assembling => Page 38-8
• O-ring
• ◆ Renew

• 3rd and 4th gear clutch -K3- with turbine shaft
• ◆ On some gearboxes the clutches -K1- and -K3- may be pressed together
• ◆ Pressing -K1- onto -K3- => Page 37-130
• ◆ When installing, rotate clutch until all the inner plates have meshed
• ◆ Dismantling and assembling => Page 38-20
• Axial needle bearing with washer
• ◆ Lightly lubricate washer with ATF so that bearing sticks to 3rd and 4th gear clutch
• ◆ Install axial needle bearing facing toward small input shaft
• Small input shaft

• Needle bearing
• Axial needle bearing
• Large input shaft
• Axial needle bearing
• Axial needle bearing washer
• ◆ With shoulder
• ◆ Installation position: Shoulder faces toward large sun gear
• Large sun gear
• Axial needle bearing
• Axial needle bearing washer
• Gearbox housing with free wheel and circlips installed

• Planet carrier shim
• ◆ Determining thickness, => Adjusting planet carrier, Page 37-133
• Washer
• Bolt - 30 Nm
• ◆ For small input shaft
• Sealing cap
• ◆ Drive in with fitting sleeve 40-20