Audi Workshop Service and Repair Manuals

Special tools and workshop equipment required

• ◆ Hose clamps 3094

• ◆ Drip tray V.A.G 1306

Removing

• ‒ → Screw out 5 bolts -arrows-.
• ‒ Remove air duct -1- and -2-.

• ‒ → Clamp off coolant hoses to cooling circuit fuel cooler with hose clamps 3094.
• ‒ Detach top coolant hose -1-.
• ‒ Remove front bumper:

=> General Body Repairs, Exterior; Repair Group 63; Front Bumper; Removing and installing front bumper

• ‒ Place drip tray V.A.G 1306 below engine.
• ‒ → Disconnect -bottom-2- coolant hose from fuel cooling circuit cooler -1.
• ‒ Unbolt fuel cooling circuit pump -3-.
• ‒ Detach fuel cooling circuit cooler.

Installing

Install in reverse order, paying attention to the following:

• ‒ Fit front bumper.

=> General Body Repairs, Exterior; Repair Group 63; Front Bumper; Removing and installing front bumper

• ‒ Fill cooling system with coolant => Page 19-11.

Tightening torque