Audi Workshop Service and Repair Manuals

• Sump
• ◆ Removing and installing
• ◆ Clean sealing surface before installing
• ◆ Before fitting sump, apply a small amount of sealant "AMV 174 004 01" to front and rear sealing points between sealing flanges and cylinder block

=> Parts List

• Gasket
• ◆ Replace
• ◆ Install dry
• ◆ Apply a small amount of sealant "AMV 174 004 01" only to sealing points between sealing flange and cylinder block (front and rear)

=> Parts List

• Suction pipe
• ◆ Clean strainer if soiled
• 10 Nm
• 25 Nm
• Longitudinal strut, right
• 25 Nm
• Stop plate
• ◆ For torque reaction support
• ◆ Adjusting:
• ‒ Allow stop for torque reaction support to rest on rubber buffer for torque reaction support under its own weight, and tighten bolts to 25 Nm.
• 25 Nm

• 25 Nm
• Bracket
• ◆ For torque reaction support
• Spacer
• 25 Nm
• Longitudinal strut, left
• 20 Nm
• Oil pump housing
• Gears
• ◆ Checking backlash
  => Fig.1
• ◆ Checking ring gap => Fig.2
• Oil pump cover with pressure relief valve
• ◆ Opening pressure: 5.7 ... 6.7 bar

• 10 Nm
• 25 Nm
• O-ring
• ◆ Replace
• Engine/gearbox support
• ◆ Remove for removal of sump => Page 17-11
• ◆ When installing with engine removed from vehicle, ensure that engine/gearbox support is positioned flush with intermediate plate at flywheel end (i.e. engine/gearbox support should protrude 0.8 mm from cylinder block).
• 45 Nm

• 25 Nm (bolt M8)
  45 Nm (bolt M10)
• Oil drain plug - 30 Nm
• Gasket
• ◆ Replace
• 18 Nm
• ◆ Tighten in stages and in diagonal sequence