A4 Mk1
Toothed belt drive - exploded view |
1 - | Bolt |
q | 10 Nm |
2 - | Bolt |
q | 10 Nm |
3 - | Nut |
q | 10 Nm |
4 - | Bolt |
q | 20 Nm |
5 - | Toothed belt cover (top) |
6 - | Toothed belt |
q | Check for wear |
q | Do not kink |
q | Before removing, mark direction of rotation with chalk or felt-tipped pen |
q | Removing → Chapter |
q | Installing (adjusting valve timing) → Anchor |
7 - | Bolt |
q | 25 Nm |
8 - | Nut |
q | 10 Nm |
9 - | Washer |
10 - | Bolt |
q | Use counterhold tool -3036- when loosening and tightening |
q | Tightening torque → Item |
11 - | Washer |
12 - | Camshaft sprocket |
q | For exhaust camshaft |
q | Remove toothed belt prior to removing and installing → Chapter |
13 - | Tensioning roller |
14 - | Fitted bolt |
q | For tensioning roller |
q | 25 Nm |
15 - | Toothed belt cover (rear) |
16 - | Bolt |
q | 20 Nm |
17 - | Idler gear |
18 - | Washer |
19 - | Crankshaft sprocket |
q | Contact surface between sprocket and crankshaft must be free of oil |
q | Can only be installed in one position |
20 - | Bolt |
q | Renew |
q | Do not lubricate with oil |
q | Use counterhold tool -3415- to loosen and tighten |
q | 90 Nm + 90° |
21 - | Bolt |
q | Use counterhold tool -3036- when loosening and tightening |
q | 65 Nm |
22 - | Tensioner for toothed belt |
23 - | Bolt |
q | 10 Nm |
24 - | Idler roller |
25 - | Bolt |
q | 25 Nm |
26 - | Toothed belt cover (bottom) |
q | Unbolt vibration damper prior to removing |