Audi Workshop Service and Repair Manuals

• Bolt (special type)
• ◆ Use only correct bolts (same as original equipment); strength rating 10.9

=> Parts catalogue

• ◆ Tighten to 20 Nm
• ◆ Tighten in stages and in diagonal sequence

• Sump
• ◆ Removing and installing
  
• ◆ Clean sealing surfaces before installing
• ◆ Before installing sump, apply a small amount of sealant
  "AMV 174 004 01" to sealing points between sealing flange and cylinder block

• Gasket
• ◆ Renew
• ◆ Install dry
• ◆ Apply a small amount of sealant "AMV 174 004 01" only to sealing points between sealing flange and cylinder block (front and rear)
• O ring
• ◆ Renew
• Suction pipe
• ◆ Clean strainer if soiled
• 10 Nm
• Baffle plate
• Bracket
• ◆ For torque reaction support
• ◆ Version for vehicles with air conditioner

• Stop
• ◆ For torque reaction support
• ◆ Adjusting:
• ‒ Allow stop for torque reaction support to rest on rubber buffer for torque reaction support under its own weight, and tighten bolts to 25 Nm.
• 25 Nm
• 25 Nm
• 25 Nm
• Support
• 25 Nm
• Longitudinal strut
• ◆ Version for vehicles with air conditioner

• 20 Nm
• Oil pump housing
• Gears
• ◆ Checking backlash
  => Fig. 1
• ◆ Checking axial clearance
  => Fig. 2
• Oil pump cover with pressure relief valve
• ◆ Opening pressure: 5.7...6.7 bar
• 10 Nm
• 25 Nm
• Bracket
• ◆ For intake manifold
• 20 Nm

• 45 Nm
• Engine/gearbox support
• ◆ Remove support in order to remove sump => Page 17-10
• ◆ When installing engine/gearbox support with engine removed from vehicle, ensure that support is positioned flush with intermediate plate at flywheel end (i.e. engine/gearbox support should protrude 0.8 mm from cylinder block).
• Oil drain plug - 30 Nm
• Seal
• ◆ Renew