|
Dismantling and assembling engine
Removing and installing bracket for alternator, vane pump (power steering) and viscous fan
-
● Lock carrier must be in service position .
Removing
-
‒ Obtain radio code on vehicles with coded radio.
-
‒ With ignition switched off disconnect battery earth strap.
-
‒ Remove ribbed belt and tensioning element for ribbed belt => Page 13-17.
Note:
Ribbed belt for air conditioner does not have to be removed.
-
‒ Remove V-belt=> Page 13-20.
-
‒ Unbolt pulley from vane pump for power sterring.
-
‒ Unbolt vane pump from bracket for alternator, vane pump and viscous fan, lift clear to one side and tie in place. Do not disconnect hydraulic connections.
-
‒ Perform all steps listed under "Removing and installing coolant pump" => Page 19-13.
Note:
Coolant pump is bolted to bracket for alternator, vane pump and viscous fan.
Installing
Installation is carried out in the reverse order, when doing this note the following:
-
‒ Renew coolant pump seal to prevent leaks.
Tightening torques
|
|
|---|
|
Component
|
|
Nm
|
|
Belt pulley to vane pump
|
|
25
|
|
Vane pump to bracket for alternator, vane pump and viscous fan
|
25
|
| 
