Audi Workshop Service and Repair Manuals

Note:

• ◆ Always replace seals and gaskets.

• Main bearing cap bolts
• ◆ Replace
• ◆ 60 Nm + 180° (1/2 turn)
• Crankshaft main bearing cap
• ◆ Identification -1- on oil pump side
• ◆ Replace bolt for main bearing caps
• ◆ Checking bearing clearance
• Conrod bearing bolts
• ◆ Replace
• ◆ 30 Nm + 90° (1/4 turn)
• ◆ To measure radial clearance tighten to 20 Nm but not further

• Conrod journal
• ◆ Do not interchange used bearing shells
• ◆ Conrod, conrod bearing
• Piston ring
• ◆ Checking
• Piston
• ◆ Checking => Page13-23
• Crankshaft
• ◆ Checking => Page 13-23
• Oil pump
• ◆ Removing and installing => Page 17-2
• 10 Nm
• Thrust washer
• ◆ Measuring axial clearance of crankshaft
• ◆ On 4th crankshaft bearing only

• 60 Nm +90°(1/4 turn)
• ◆ Vehicles with automatic gearbox

• 11 - 40 Nm + 180° (1/2 turn)
• ◆ Vehicles with manual gearbox

• Flywheel/driven plate
• ◆ Removing and installing
• ◆ Removing and installing needle bearing =>Page13-17
• ◆ Adjust bracket of sender for engine speed, Repair Group 28
• Crankshaft bearing
• ◆ Checking axial and radial clearance => Page 13-21
• Sealing ring
• ◆ Replacing => Page 13-21.
• 10 Nm
• 25 Nm
• ◆ Screw in bolts by hand before tightening the main bearing caps
• Crankcase