→ Attachment of accelerator cable sleeve
-
‒ Push accelerator cable through bulkhead, push accelerator cable into bulkhead and turn anti-clockwise by approx. 90°
Adjust throttle cable
Notes:
-
◆ The throttle cable is very sensitive to kinking and must therefore be handled carefully when installing. A single slight kink can cause it to break when driving. Bent cables must not be installed.
-
◆ When installing ensure that the accelerator cable is aligned between its support bearings and the cable attachment points.
-
‒ Pull off guard for accelerator cable to throttle valve unit.
-
‒ Depress accelerator pedal into full throttle position.
Note:
This requires a second mechanic or it must be supported with spring rod against steering wheel.
Vehicles with manual gearbox
-
‒ Pull off accelerator cable sleeve from cam plate on throttle valve until throttle flap is fully opened.
Vehicles with automatic gearbox:
-
‒ Pull back accelerator cable sleeve in full throttle position until throttle flap is fully opened and the kick down switch audibly clicks in. Hold tight
-
‒ Insert retainer clip for accelerator cable sleeve.
-
‒ Release accelerator pedal or remove spring tensioning rod.
Note:
After adjusting the idling and the full throttle stop of throttle valve must be controlled.
|