Removing and installing coolant pipe (small) |
–
| Disconnect rear coolant hose from coolant pipe (small). |
–
| Pull off small coolant pipe to rear. |
–
| Take out coolant pipe from the top. |
Installation is carried out in the reverse order; note the following: |
Note t
| Secure all hose connections with the correct type of hose clips (same as original equipment) → Parts catalogue. |
–
| Clean and smoothen sealing surface for O-ring as required. |
–
| Lubricate new O-rings with “G12” and slide onto coolant pipe. |
–
| Push coolant pipe into bore on cylinder block. |
|
|
|