A4 Mk1
| Poly V-belt drive - exploded view of components |
| 1 - | 11 Nm |
| 2 - | Fan wheel for viscous fan |
| q | Removing and installing → Chapter |
| 3 - | Poly V-belt |
| q | Before removing, mark direction of rotation with chalk or felt-tipped pen. If the belt runs in the opposite direction when it is refitted, this can cause breakage. |
| q | Removing and installing → Chapter |
| 4 - | 22 Nm |
| 5 - | Alternator |
| q | Removing and installing → Rep. Gr.27 |
| 6 - | 45 Nm |
| 7 - | 22 Nm |
| 8 - | Bracket for alternator |
| 9 - | 45 Nm |
| 10 - | Not fitted |
| 11 - | 55 Nm |
| 12 - | 22 Nm |
| 13 - | Pulley for power steering pump |
| q | To remove and install: counterhold with pin wrench -3212- → Fig. |
| q | Marked “Vorne/Front” |
| 14 - | Pressure line |
| q | To power-assisted steering |
| 15 - | Banjo bolt, 47 Nm |
| 16 - | Seal |
| q | Renew |
| 17 - | 22 Nm |
| 18 - | Power steering pump with bracket |
| q | Removing and installing → Rep. Gr.48 |
| 19 - | 22 Nm |
| 20 - | Pulley for viscous fan |
| q | Removing and installing → Fig. |
| 21 - | Tensioner for poly V-belt |
| 22 - | 25 Nm |
| 23 - | Air conditioner compressor |
| q | Do not unscrew or disconnect refrigerant hoses or pipes. |
| q | After removing compressor from mountings, secure it to longitudinal member with wire or similar. Do not leave it suspended from refrigerant pipes. |
| 24 - | M6: 10 Nm; M8: 22 Nm |
| 25 - | Vibration damper |
| q | Removing and installing → Chapter |
| 26 - | 22 Nm |
| 27 - | Viscous fan coupling |
| q | Removing and installing → Chapter |
|
|
