-
‒ → Unscrew fuel rail -arrows-.
-
‒ Pull fuel distributor rail together with injectors off intake manifold and place it on a clean cloth at the back of the engine compartment.
Important: The fuel system is pressurised! Before opening the system place a cloth around the connection. Then release pressure by carefully loosening the connection.
-
‒ Pull off retainer and detach injector.
Note:
Replacement of fuel manifold involves detaching fuel hoses.
Install in reverse order, paying attention to the following:
-
● Renew the O-rings at all opened connections. (when renewing the front O-ring, ensure that the plastic cap is not removed from the injector head. The O-ring must be pulled off over the plastic cap).
-
● Moisten the O-rings with clean engine oil.
-
● Make sure that the injectors are installed in the correct positions.
-
● Check to make sure that the retainer clamps are properly seated.
-
● Position fuel manifold with secured injectors on intake manifold and press evenly into place.
Tightening torque
|
---|
Component
|
|
Nm
|
Fuel distributor rail to intake manifold
|
10
|
|