|
Servicing Multi Point Injection system
Rules for cleanliness
When working on the fuel supply/injection system, pay careful attention to the following "6 rules":
-
◆ Thoroughly clean all unions and the adjacent areas before disconnecting.
-
◆ Place removed parts on a clean surface and cover. Do not use fluffy cloths!
-
◆ Carefully cover or seal open components if repairs cannot be carried out immediately.
-
◆ Only install clean components:
Only remove replacement parts from packaging immediately prior to installation.
Do not use parts that have been stored loose (e.g. in tool boxes etc.).
-
◆ When the system is open:
Do not work with compressed air if this can be avoided.
Do not move vehicle unless absolutely necessary.
-
◆ Separate electrical connections:
Protect from dirt and moisture.
Make sure connections are dry when attaching.
| 
