| Notes on repairs to wiring harnesses and connectors |
| t
| Soldering is not permitted when repairing the vehicle electrical system. |
| t
| Do not perform repairs on heat-shrink sleeves. Route a new wire along the defective wire if necessary. |
| t
| Screened wires, e.g. on speed senders and knock sensors, are NOT to be repaired. These wires must be replaced complete if damaged. |
| t
| Only use yellow wires for repairs to wiring. Mark location of repair with yellow insulating tape. |
| t
| Yellow wiring and locations with yellow insulating tape on wiring harness designate a previous repair. |
|
|
|
