audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking data exchange between control units > < Encoding control unit

A4 Mk1

Reading measured value block
Reading measured value block
   
Sequence of operations
–  Start automatic headlight range control self-diagnosis → Chapter.
Display on -VAS 5051B-:
–  From list -1-, select function “08 - Reading measured value block”.
  A01-0122
Display on -VAS 5051B-:
1 - Enter display group
–  Use keypad -2- to enter the desired “display group number” → Anchor and confirm the entry by touching the Q key.
  A01-0130
Display on -VAS 5051B-:
1 - Display zones 1 ... 4. If a display zone is not assigned, there is no display on this line.
2 - The display group selected is shown here
3 - Touching these keys permits switching to a different display group.
4 - Touching these keys permits switching to a different function (e.g. from “Reading measured value block” to “Basic setting” and vice versa).
–  Terminate function “08 - Reading measured value block” by touching ← key.
  A01-0176
List of display groups
Display group 001
Display zonesExplanatory notes
1… VPower supply (terminal 15)
2… VDipped beam voltage via terminal 56b
3… km/hVehicle speed
4 Not used

   
Display group 002
Display zonesExplanatory notes
1 Front left vehicle level sender -G78- voltage value
… V
l  1.66 … 3.45 V
2 Rear left vehicle level sender -G76- voltage value
… V
l  1.66 … 3.45 V
3 Control motor actuation
…
l  ADP. in progress (compensation for control difference is provided by actuating control motors)
l  ADP. OK (control position set)
4 Not used

   

Checking data exchange between control units > < Encoding control unit