A4 Mk2
| Removing and installing trim panel for B-pillar |
| 1 - | Trim panel for B-pillar |
| Removing: |
| q | Unclip cover -7-. |
| q | Remove bolts -6- and detach trim panel outwards. |
| Installing: |
| q | With rear door open, insert trim panel in retainer. |
| q | With rear door closed, position trim panel at top and bottom, as shown in detail sections. |
| q | Screw in front bolt -6-. |
| q | The outer lip of the rear door window seal should make even contact all the way down the trim panel. |
Note| Ensure that the seal does not press too hard onto the trim panel, as the lip of the seal could otherwise project and cause wind noise. |
| q | Screw in rear bolt -6- with door open. |
| q | Press grommet -5- into trim panel. |
| q | Push on cover -7- from below. |
| 2 - | Bolt |
| q | 1.5 Nm |
| 3 - | Retainer |
| 4 - | Clip |
| 5 - | Grommet |
| 6 - | Bolt with washer |
| q | 5 Nm |
| 7 - | Cover |
