A4 Mk2
Removing and installing window frame and window regulator |
1 - | Window frame |
q | Removing: |
q | Remove door trim → Trim, insulation; Rep. gr.70. |
q | Unplug electrical connectors. |
q | Remove window regulator motor → Fig. |
q | Remove bolts -7-. |
q | Unscrew bolts -4-, -8- and -10-. |
q | Unscrew bolts -6- and -9- and lift window frame with window regulator out of door. |
q | Installing: |
q | Before installing, move half of window glass into window frame. |
q | Insert window frame and window regulator into door from above. |
q | Attach upper half of seal (on door side) into window frame (top). |
q | Loosely screw in securing bolts in the following sequence: -6-, -9-, -3-, -8- and -10-. |
q | Hand-tighten fitted bolts -6- and -9-. |
q | Press top of window frame -1- slightly inwards. |
q | Tighten bolts -4- and -8- to 32 Nm. |
q | Tighten fitted bolts -6- and -9- to 32 Nm. |
q | Tighten bolt -10- to 10 Nm. |
q | Tighten locking bolt -arrow- in window frame to 32 Nm. |
2 - | Window regulator |
q | Bolted to window frame for installation in door |
3 - | Front door |
4 - | Torx bolt |
q | 32 Nm |
5 - | Cap |
6 - | Fitted bolt |
q | 32 Nm |
7 - | Flange bolt |
q | 6 Nm |
8 - | Torx bolt |
q | 10 Nm |
9 - | Fitted bolt |
q | 32 Nm |
|
|
|