Exploded view - windscreen for A4 Mk2 body repairs and glazing
| Exploded view - windscreen |
| 1 - | Windscreen |
| q | Removing → Chapter |
| q | Installing → Chapter |
| q | Distance to roof: dimension -a- = 6 mm +0.5 mm |
| q | Align centrally between A-pillars. |
Note| Re-attach stickers for windscreen (e.g. for airbag) at same locations on new windscreen. |
| 2 - | Adhesive bead |
| q | Note drying times → Chapter. |
| q | Note differing distances from edge of windscreen: |
| q | Dimension -b- = 4 mm is obtained if tip of nozzle makes contact with moulding (top) when adhesive is applied. |
| q | Distance from edge of windscreen (sides): dimension -d- = 4 mm. |
| q | Gap at bottom edge of windscreen measured from clip: dimension -c- = 10 mm |
| q | Bead cross-section |
| q | Width of bead = 8 ± 2 mm |
| q | Height of bead = 13.5 +1.5 mm |
| 3 - | Spacer |
| q | 5x |
| q | Bond onto fastening strip at even distances |
| 4 - | Protective strip |
| q | Only on new part |
| q | Remove after installing windscreen and before installing plenum chamber cover |
| 5 - | Plenum chamber cover |
| q | Pull protective strip -4- out of fastening strip before fitting plenum chamber cover. |
| q | Allow glass adhesive to dry before pressing plenum chamber cover into retaining strip. |
