A4 Mk2
|
|
|
|
WARNING
|
1 - | Fastening strip (side) |
2 - | Connector for side airbag |
3 - | Latch |
4 - | Side airbag (driver side/front passenger side) |
t | Removing |
– | Disconnect battery earth strap → Electrical system; Rep. gr.27. |
– | Remove seat: |
t | Standard seat: vehicles from 11.2004 onwards → Chapter |
t | Seat with electric adjustment: vehicles from 11.2004 onwards → Chapter |
t | Recaro seat from 11.2004 onwards → Chapter |
– | Attach seat repair stand -VAS 6136- to engine and gearbox support -VAS 6095-. |
– | Attach front seat to seat repair stand -VAS 6136-. |
– | Remove backrest cover panel: |
t | Standard seat: vehicles from 11.2004 onwards → Chapter |
t | Seat with electric adjustment: vehicles from 11.2004 onwards → Chapter |
t | Recaro seat from 11.2004 onwards → Chapter |
– | Use screwdriver to prise out fastening strips (bottom) -9- (3x). |
– | Use screwdriver to prise out fastening strip on side -1- and fold cover forwards. |
– | Cut through upholstery clips -10- (4x) at protective cover for side airbag -6-. |
– | Push latch -3- downwards and unplug connector for side airbag -2-. |
– | Unscrew bolt -7-. |
– | Drill out rivet -5-. |
– | Push side airbag -4- upwards and take out side airbag. |
t | Installing |
Install in reverse order of removal. Note the following: |
– | Engage side airbag -4- in backrest frame. |
– | Push side airbag -4- down as far as it will go. |
– | Position lug of earth wire -11- between backrest frame and side airbag -4-. |
– | Secure earth wire -11- with a rivet. |
– | Renew bolt -7-. |
– | Secure side airbag -4- with bolt -7-. |
– | Make sure airbag cable -13- runs through cable guide -14- and is attached to backrest frame using clip -12-. |
– | Use upholstery clip pliers -V.A.G 1634- to install new upholstery clips on protective cover for side airbag. |
– | Switch on ignition. |
WARNING
|
– | Connect battery earth strap → Electrical system; Rep. gr.27. |
Note
t | Observe measures to be taken after connecting the battery → Electrical system; Rep. gr.27. |
t | If the airbag warning lamp -K75- indicates a fault following installation, you must interrogate, erase and then re-interrogate the event memory → Vehicle diagnostic tester. |
5 - | Rivet |
6 - | Protective cover for side airbag |
7 - | Bolt |
q | Tightening torque: 10 Nm |
q | Always renew after removing |
8 - | Front seat |
9 - | Fastening strips (bottom; 3x) |
10 - | Upholstery clips (4x) |
11 - | Earth wire |
12 - | Clip |
13 - | Airbag wire |
14 - | Cable guide |