A4 Mk2
| Removing and installing four-way lumbar support control motors |
| 1 - | Backrest with active head restraint system |
| q | Up to 06.2006 (country-specific version) |
| q | Up to 11.2006 (RoW) |
| 2 - | Backrest padding |
| q | From 06.2006 onwards (country-specific version) |
| q | From 11.2006 onwards (RoW) |
| 3 - | Backrest without active head restraint system |
| q | From 06.2006 onwards (country-specific version) |
| q | From 11.2006 onwards (RoW) |
| 4 - | Spring |
| q | 2x |
| q | For engaging four-way lumbar support (lumbar support) in backrest frame |
| q | From 06.2006 onwards (country-specific version) |
| q | From 11.2006 onwards (RoW) |
| 5 - | Frame for four-way lumbar support |
| q | From 06.2006 onwards (country-specific version) |
| q | From 11.2006 onwards (RoW) |
| 6 - | Clamp |
| q | Up to 06.2006 (country-specific version) |
| q | Up to 11.2006 (RoW) |
| 7 - | Frame for four-way lumbar support |
| q | Up to 06.2006 (country-specific version) |
| q | Up to 11.2006 (RoW) |
| 8 - | Four-way lumbar support control motor |
| q | Removing: |
Note| When renewing control motor, four-way lumbar support must not be in an end stop position. |
| – | Remove backrest cover panel → Chapter. |
| – | Unplug electrical connector → Fig.. |
| – | Release retaining bracket and take control motor out downwards → Fig.. |
| q | Installing: |
| Installation is carried out in the reverse order, note the following: |
| – | The control motor can only be installed in one position. |
| 9 - | Centring pin |
| For centring four-way lumbar support with four-way lumbar support frame |
| 10 - | Rivet |
| 11 - | Plastic washer |
| 12 - | Control motor for adjusting height of four-way lumbar support |
| Removing |
Note| When renewing control motor, four-way lumbar support must not be in an end stop position. |
| – | Remove backrest cover panel → Chapter. |
| – | Unplug electrical connector → Fig.. |
| – | Release retaining bracket and lift out control motor → Fig.. |
| Installing |
| Installation is carried out in the reverse order, note the following: |
| – | The control motor can only be installed in one position. |
| 13 - | Four-way lumbar support |
| 14 - | Fastening strips |
| 15 - | Backrest padding |
| q | Up to 06.2006 (country-specific version) |
| q | Up to 11.2006 (RoW) |
