A4 Mk2
|
|
|
|
|
| 1 - | Cable tie |
| q | 2x |
| 2 - | Spring mat with wiring harness |
| t | Removing: |
| – | Remove seat → Chapter. |
| – | Attach seat repair stand -VAS 6136- to engine and gearbox support -VAS 6095-. |
| – | Attach front seat to seat repair stand -VAS 6136-. |
| – | Remove side trim (sill side) → Chapter. |
| – | Remove side trim (tunnel side) → Chapter. |
| – | Remove backrest → Chapter. |
| – | Remove drawer → Chapter. |
| – | Remove seat pan cover and padding → Chapter. |
| – | Remove cable ties -1- (4x). |
| – | Disengage spring mat -2- at locations marked -A- (2x). |
| – | Disengage spring mat -2- at locations marked -B- (4x). |
| – | Tilt seat pan to the side. |
| – | Unplug connectors -3-, -7- and -8- (3x). |
| – | Unplug connectors -11- (2x). |
| – | Slacken off bolt -10-. |
| – | Unfasten wiring harness from clips -4- and -5- (4x). |
| – | Detach spring mat with wiring harness -2-. |
| t | Installing: |
| Install in reverse order of removal. |
| 3 - | Connector |
| 4 - | Clip |
| q | 2x |
| 5 - | Clip |
| q | 2x |
| 6 - | Wiring harness |
| 7 - | Connector |
| 8 - | Connector |
| 9 - | Washer |
| 10 - | Bolt |
| q | 3.5 Nm |
| 11 - | Connector |
| q | 2x |
