A4 Mk2
Unplugging electrical connectors |
1 - | Cover for connector point |
Removing |
– | Remove seat → Chapter. |
– | Tilt front seat -2- backwards. |
– | Lift off cover for connector point -1-. |
– | Press in tab at current supply connector -5- (tunnel end) and unplug current supply connector. |
– | Press in tab at seat heating connector -4- (tunnel side) and unplug seat heating connector. |
Vehicles with belt buckle sensor: |
– | Press in tab at belt buckle sensor connector -3- (tunnel end) and unplug belt buckle sensor connector. |
Installing |
Install in reverse order of removal. |
2 - | Front seat |
3 - | Connector for belt buckle sensor (black) |
q | Depending on equipment |
4 - | Connector for seat heating (green) |
5 - | Connector for current supply (red) |
6 - | Connector housing with terminating resistor for side airbag |
q | Depending on the version, this terminating resistor is either attached directly to wiring harness, or fitted as a separate connector housing with terminating resistor |
q | Fitting location → Chapter |