audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Items to be checked following complete assembly of backrest > < Removing and installing cover and padding for 1/3 section of rear seat backrest
Removing and installing cover and padding for 2/3 section of rear seat backrest
   
Removing and installing cover and padding for 2/3 section of rear seat backrest
t  Removing:
–  Remove backrest → Chapter.
–  Remove bolts -2- (2x) of latch trim -1-.
–  Press latch lever -3- in direction of arrow.
–  Lift off latch trim -1-.
–  Remove head restraints -4-:
t  Head restraints with slide-in locking mechanism → Chapter
t  Head restraint without slide-in locking mechanism → Chapter
–  Remove head restraint guides -5-:
t  Head restraint guides with slide-in locking mechanism → Chapter
t  Outer head restraint guides without slide-in locking mechanism → Chapter
t  Inner head restraint guides without slide-in locking mechanism → Chapter
–  Remove centre armrest -11-.
–  Remove load-through hatch -11- → Chapter.
–  Use screwdriver to prise out cover for three-point seat belt -12-.
–  Prise plastic strip -6- (4x) out of brackets -7- (4x).
–  Detach plastic strip -8- (4x) from bracket.
–  Use screwdriver to prise out peripheral plastic strip (rear) -13-.
–  Detach padding -15- from backrest pan -9-.
–  Fold over cover -14-.
–  Use screwdriver to prise fastening strip -16- out of plastic clip -17-.
–  Remove cover -14-.

   
1 - Latch trim
2 - Bolt (2x)
3 - Latch lever
4 - Head restraint (2x)
q   Rear outer head restraints are not identical to front head restraints.
q   If all head restraints are removed together mark them accordingly with adhesive tape.
5 - Head restraint guide (4x)
q   Removing and installing → Chapter
q   Install head restraint guide with button (left-side).
6 - Plastic strip (4x)
7 - Brackets (4x)
8 - Plastic strip (4x)
9 - Backrest pan
10 - Centre armrest
11 - Load-through hatch (for ski bag)
12 - Cover for three-point seat belt
13 - Plastic strip (rear, peripheral)
14 - Seat cover
15 - Padding
16 - Fastening strip
17 - Plastic clips
q   Renew plastic clips if damaged

   

Items to be checked following complete assembly of backrest > < Removing and installing cover and padding for 1/3 section of rear seat backrest