A4 Mk2
| Removing and installing floor covering |
| 1 - |
| t | Removing: |
| – | Remove front seats (left and right) → Chapter. |
| – | Remove seat bench (rear): vehicles up to 10.2004 → Chapter, vehicles from 11.2004 onwards → Chapter. |
| – | Remove A-pillar trim (bottom, left and right) → Chapter. |
| – | Remove B-pillar trim (bottom, left and right) → Chapter. |
| – | Remove foot rest (driver side) → Chapter. |
| – | Remove centre console → Chapter. |
| – | Unfasten wiring harness beneath centre console. |
| – | Unfasten rubber plug -4- beneath centre console and unscrew bolt -5-. |
| – | Take wiring harness out of vehicle. |
| – | Remove air ducts at centre console. |
| – | Slacken off bolt -3- at lug of floor covering at front of footwell. |
| – | Fold up floor covering lengthways and take out of vehicle. |
| t | Installing: |
Note| Floor covering is liable to tear easily at cut-outs. Fit floor covering in vehicle carefully. |
| – | Fold up new floor covering lengthways and place in vehicle. |
| – | Before fitting a new floor covering -1-, remove transportation crosspiece -2-. |
| – | Install floor covering in reverse order of removal. |
| 2 - | Transportation crosspiece |
| 3 - | Bolt |
| 4 - | Rubber plug |
| 5 - | Bolt |
