A4 Mk2
|
|
|
| 1 - | Luggage compartment trim |
| t | Removing: |
| – | Take out luggage compartment floor covering → Chapter. |
| – | Remove rear cross panel trim → Chapter. |
| – | Remove rear seat backrest → Chapter. |
| – | Fold fastening ring -5- (1x or 2x depending on version) up. |
| – | Loosen the two cross-head screws -6- in fastening rings. |
| – | Unfasten clip -3-. |
| – | Disengage clip -3- from tab. |
| – | Release the three clips -4-. |
| – | Remove cover -2- if necessary. |
| – | Lift off luggage compartment trim -1-. |
| t | Installing: |
| Install in reverse order of removal. Observe the following: |
| – | After completing installation, fold rubber seal for rear lid over trim -1-. |
| 2 - | Cover |
| 3 - | Clip |
| 4 - | Clips (3x) |
| 5 - | Fastening rings |
| 6 - | Bolts (2x) |
| q | Tightening torque: 4 Nm |
