A4 Mk2
|
|
|
| 1 - | Rear shelf |
| t | Removing: |
| – | Fold down rear seat backrest. |
| Non-folding rear seat backrest: |
| – | Remove rear seat backrest → Chapter. |
| – | Remove D-pillar trim (left and right) → Chapter. |
| – | Remove rear side padding (left and right) → Chapter. |
| – | Unplug connector to third brake light. |
| Fixed rear seat backrest: |
| – | Unfasten third belt at bottom and guide it through. |
Note| The following describes three different removal methods depending on whether a rear shelf without extra fittings, with loudspeaker or with loudspeaker and sun blind is to be removed. The operations then listed under „All models“ apply to all three methods. |
| Removal, version 1: Rear shelf without extra fittings |
| – | Continue removal procedure as described in „All models“. |
| Removal, version 2: Rear shelf with integrated loudspeaker |
| – | Take loudspeaker grille -3- out of rear shelf -1-. |
| – | Loosen the four bolts -5- between loudspeakers and rear shelf -1-. |
| Removal, version 3: Rear shelf with integrated loudspeaker and sun blind |
| – | Take loudspeaker grille -3- out of rear shelf -1-. |
| – | Loosen the two bolts -5- at front corners of loudspeaker and bolt -5- from underneath. |
| – | Loosen the three bolts of sun blind -4- in luggage compartment (from underneath) → Fig.. |
| – | Pull out sun blind -4- to front. |
| All models: |
| – | Pull rear shelf -1- forwards in direction of arrow and disengage at connection strip -2-. |
| – | Take out rear shelf -1- upwards and to front. |
| t | Installing: |
| Install in reverse order of removal according to version. |
| 2 - | Connection strip for rear shelf |
| 3 - | Loudspeaker (grille) |
| 4 - | Sun blind |
| 5 - | Bolts between loudspeaker and rear shelf |
| q | 3 or 4 bolts in differing positions depending on version |
|
|
