audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing lateral acceleration sender G200 and yaw rate sender G202 > < Removing and installing parts of ABS/ESP system

A4 Mk2

Removing and installing brake light switch
Removing and installing brake light switch
  Note
t  The brake light switch must be removed in order to adjust it.
t  To ensure a secure fit, the switch may only be fitted once.
Removing
–  Unplug electrical connector.
–  Turn brake light switch anti-clockwise 45° to remove.
Installing
Installation is performed in reverse sequence; note the following:
   
–  Pull out plunger of brake light switch as far as it will go -arrow-.
–  Fit retainer tabs -1- and -2- on switch into recesses in mounting hole.
–  Remove driver's storage compartment: → Rep. Gr.68
  Note
t  When installing, brake pedal must not be pressed.
t  The plunger adjusts itself automatically when the brake light switch is inserted.
  A46-0188
–  Guide switch through mounting hole, press against pedal and secure by turning 45° clockwise.
After adjusting the brake light switch check whether the brake pedal is on the end stop (rest position).
  N46-0353

Removing and installing lateral acceleration sender G200 and yaw rate sender G202 > < Removing and installing parts of ABS/ESP system