A4 Mk2
|
WARNING
| 1 - | Hexagon socket head bolt, 10 Nm |
| 2 - | Accelerator pedal module |
| q | Screw into pedal bracket |
| 3 - | Mounting bracket |
| q | Stop plate for accelerator pedal |
| 4 - | Brake pedal |
| q | Fit onto pedal bracket |
| q | Engage brake pedal in brake servo (you should hear it click into place). |
| 5 - | Washer |
| 6 - | Bearing tube |
| 7 - | Clutch pedal |
| q | Located in position by adjusting clutch master cylinder |
| 8 - | Bolt with washer, 25 Nm |
| q | To dash panel cross member |
| q | Tighten in vehicle after brake servo has been installed |
| 9 - | Socket head bolts with pins, 5 Nm |
| q | To pedal bracket |
| q | Serve as retainers for outer bearing tube |
| 10 - | Brake light switch |
| q | Removing and installing |
| 11 - | Clutch switch |
| 12 - | Bolt with washer, 20 Nm |
| q | Always renew |
| 13 - | Master cylinder |
| q | Seal must not be removed. |
| 14 - | Washer |
| 15 - | Lever |
| 16 - | Hexagon bolt |
| q | Always renew |
| q | Thread in brake pedal, 25 Nm |
| 17 - | Spring |
| q | White spring mounting to pedal bracket, black spring mounting to clutch pedal |
| 18 - | Pedal bracket |
| 19 - | Jointing pin |
| q | Fit pedal bracket onto jointing pin. |
| 20 - | Dash panel cross member |
