–
| Clean flange at drive plate -A-. |
–
| Attach a dial gauge -B- with dial gauge holder -C- (e.g. universal dial gauge holder -VW 387-) to the compressor. |
–
| Attach probe of dial gauge -D- to flange of drive plate -A- with a pre-tension of approx. 1.0 mm. |
–
| Give compressor drive unit -E- several turns. |
Specification: Eccentricity less than 0.21 mm (dial gauge deflection, difference between lowest and highest measured value max. 0.2 mm) |
–
| If eccentricity exceeds 0.2 mm, slacken off bolts at drive plate → Chapter and re-adjust drive plate. |
|
|
|