A4 Mk2
| Servicing selector rod and push rod |
| 1 - | Gear lever bearing |
| 2 - | Bolt |
| q | 6 Nm |
| q | 4x |
| q | Secures gear lever bearing to selector housing |
| 3 - | Hexagon socket head bolt |
| q | 25 Nm |
| 4 - | Washer |
| 5 - | Hexagon socket head bolt |
| q | 25 Nm |
| 6 - | Clamp |
| 7 - | Nut |
| q | 10 Nm |
| q | 4x |
| q | Secures selector housing to body |
| 8 - | Nut |
| q | 10 Nm |
| q | Self-locking |
| q | Always renew |
| 9 - | Gear lever |
| 10 - | Bush |
| q | Lubricate with polycarbamide grease -G 052 142 A2- |
| 11 - | Selector fork |
| 12 - | Bolt |
| 13 - | Selector housing |
| 14 - | Tensioning ring |
| 15 - | Bellows |
| q | Remove catalytic converter and front heat shield before removing and installing |
Note| t | Carefully pull bellows over selector rod |
| t | Align bellows with markings on selector rod and push rod |
| 16 - | Selector rod |
| q | With selector joint |
| 17 - | Bolt |
| q | 23 Nm |
| q | Self-locking |
| q | Always renew |
| 18 - | Hexagon socket head bolt |
| q | 40 Nm |
| q | Cannot be removed from the bearing bush of the push rod |
| 19 - | Push rod |
