Note t
| Refer to general repair instructions → Chapter. |
t
| On vehicles with SAC pressure plate (self-adjusting clutch) an adjuster ring has to be reset when only the clutch plate is renewed → Chapter. |
t
| To avoid damaging SAC pressure plate when removing and installing, observe assembly instructions for SAC pressure plate → Chapter. |
t
| Renew clutch plate and pressure plate if riveted fastening is damaged or loose. |
t
| To avoid damaging dual-mass flywheel during removal, please observe instructions for removal → Fig.. |
t
| Clean input shaft splines and (in the case of used clutch plates) the hub splines. Remove corrosion and apply only a very thin coating of grease for clutch plate splines -G 000 100- to the splines. Then move clutch plate backwards and forwards on input shaft until hub moves freely on shaft. It is important to remove excess grease. |
t
| Pressure plates have an anti-corrosion coating and are greased. Only the contact surface may be cleaned, otherwise the service life of the clutch will be considerably reduced. |
t
| If the clutch has burnt out, thoroughly clean the bell housing, flywheel and parts of the engine facing the gearbox in order to prevent odours. |
|
|
|