A4 Mk2
Bearing housing, Torsen differential and end cover - exploded view |
1 - | Bearing housing |
q | Dismantling and assembling → Chapter |
2 - | Bolt, 25 Nm |
q | 6x |
3 - | Dished spring |
q | Installation position: larger diameter (concave side) towards the shims. |
4 - | Shim |
q | Qty. 2 or 3 |
q | Re-determining thickness → Anchor |
5 - | Oil collector |
q | Dismantling and assembling → Anchor |
q | Removing → Anchor |
q | Installing → Anchor |
6 - | Multi-point socket head bolt, 150 Nm |
q | Unscrew to remove → Anchor |
q | Tightening → Anchor |
7 - | 2nd inner race for ball bearing for input shaft |
q | Removing → Anchor |
q | Installing → Anchor |
8 - | Spring |
9 - | Torsen differential |
q | Can only be serviced by manufacturer |
q | Servicing bearings for Torsen differential → Chapter |
10 - | Bolt, 25 Nm |
q | 5x |
11 - | End cover |
q | Servicing → Chapter |
12 - | Gasket |
q | Renew |
13 - | Dowel sleeve |
q | 2x |
14 - | Manual gearbox |
15 - | Oil drain plug, 40 Nm |
16 - | Magnet |
q | 2x |
q | Clean |
17 - | Support plate |
q | Installation position: lugs face magnets |
18 - | Bolt, 25 Nm |
q | 2x |