A4 Mk2
Exploded view - pedal cluster (LHD vehicles) |
1 - | Mounting bracket |
q | Removing and installing → Chapter |
2 - | Pivot pin for clutch and brake pedal |
3 - | Retaining clip |
4 - | Hexagon socket head bolt |
q | 25 Nm |
5 - | Brake pedal |
q | Maintenance-free bearing, do not grease |
6 - | Clutch pedal switch -F 36- |
q | May only be installed once; must always be renewed if removed |
q | Removing and installing → Chapter |
7 - | Hexagon socket head bolt |
q | 5 Nm |
q | Secures clutch and brake pedal pivot pin |
8 - | Clutch pedal |
q | Removing and installing → Chapter |
9 - | Retaining clip |
10 - | Retaining clip |
q | Removing and installing → Item |
11 - | Hexagon socket head bolt |
q | 20 Nm |
12 - | Clutch master cylinder |
q | Removing and installing → Chapter |
q | Seal -arrow- must not be removed |
13 - | Over-centre spring |
q | Black side points towards clutch pedal |
q | Removing and installing → Chapter |
q | For correct version, refer to → Electronic parts catalogue |
14 - | Clutch pedal switch for engine start -F194- |
q | USA models and vehicles with 3.2 ltr. FSI engine only |
q | Engine can only be started when clutch is fully depressed (clutch pedal switch for engine start activated). |
q | May only be installed once; must always be renewed if removed |
q | Removing and installing → Chapter |
15 - | TORX bolt |
q | 25 Nm |
q | For securing brake master cylinder/brake servo to mounting bracket |