A4 Mk2
| Table of adjustments |
Note| If repairs have been carried out to the gearbox, it is only necessary to adjust the pinion shaft, crown wheel or final drive set if components have been renewed which have a direct effect on the adjustment of the final drive. Refer to the following table to avoid unnecessary adjustment work: |
| Components requiring adjustment: | Crown wheel | Pinion shaft | Pinion shaft | Backlash |
| („S1“ + „S2“) | („S3“ + „S4“) via allowance „r“ | Shim „S4“ only | 0.12 - 0.28 mm | |
| → Chapter | → Chapter | → Chapter | → | |
| Component renewed | ||||
| Gearbox housing 1) | X | X | X | |
| Bearing housing | X | X | ||
| Differential cage | X | X | ||
| Tapered roller bearings for pinion shaft/hollow shaft | X | X | ||
| Tapered roller bearings for differential | X | X | ||
| Final drive gear set 2) | X | X | X | |
| Cover for final drive | X | X | ||
| 1) If the gearbox housing is renewed the input shaft must also be adjusted → Chapter. 2) If necessary, pinion shaft and crown wheel must always be renewed together. | ||||