A4 Mk2
| Servicing selector rod, connecting rod and push rod |
Note| Lubricate all bearings and moving surfaces with grease -G 000 450 02-. |
| 1 - | Ball socket |
| q | To remove, bend open peened points on selector rod → Item. |
| 2 - | Washer |
| 3 - | Bearing bush |
| q | To remove pull off retaining clip → Item. |
| 4 - | Boot |
| 5 - | Gearbox selector lever |
| 6 - | Nut |
| q | 20 Nm |
| 7 - | Bolt |
| q | 20 Nm |
| 8 - | Connecting rod |
| q | To remove pull off retaining clip → Item. |
| 9 - | Retaining clip |
| 10 - | Bolt |
| q | 40 Nm |
| 11 - | Push rod |
| q | With bush, bolt → Item and washers |
| q | Washer is peened to push rod |
| q | Bush, bolt and washers cannot be removed from push rod. |
| q | Re-install push rod with the same number of washers |
| 12 - | Hexagon socket head bolt |
| q | 23 Nm |
| 13 - | Washer |
| 14 - | Gear lever bearing |
| q | Removing and installing → Chapter |
| 15 - | Tensioning ring |
| q | For bellows |
| 16 - | Bellows |
| q | To remove, carefully pull bellows over selector rod → Item and push rod → Item. |
| q | When installing, align with markings on selector rod → Item and push rod → Item. |
| 17 - | Hexagon socket head bolt |
| q | 23 Nm |
| 18 - | Clamp |
| 19 - | Selector rod |
| 20 - | Joint |
| q | For selector rod/gear lever |
| 21 - | Nut |
| q | 10 Nm |
| 22 - | Ball stud |
