A4 Mk2
| Exploded view - gear lever and gear lever bearing |
Note| Lubricate all bearings and moving surfaces with grease -G 000 450 02-. |
| 1 - | Ball |
| 2 - | Rubber ring |
| 3 - | Ball guide |
| 4 - | Rubber ring |
| 5 - | Washer |
| q | Lip points towards ball guide → Item |
| 6 - | Circlip |
| q | Take out before removing ball |
| 7 - | Spring |
| 8 - | Spacer sleeve |
| 9 - | Washer |
| q | Not fitted on all versions |
| 10 - | Circlip |
| q | Always renew |
| 11 - | Noise insulation |
| q | -Arrow- marked on noise insulation points in direction of travel |
| 12 - | Gear knob |
| q | With cover |
| q | Removing and installing → Chapter |
| 13 - | Nut, 8 Nm |
| 14 - | Gear lever bearing |
| q | Removing and installing → Chapter |
| 15 - | Bolt, 6 Nm |
| 16 - | Gear lever |
| q | Bend points towards rear |
| 17 - | Bolt |
| 18 - | Nut, 8 Nm |
| 19 - | Selector housing |
| q | Removing and installing → Chapter |
| 20 - | Joint body |
| q | For selector rod/gear lever |
| 21 - | Nut, 10 Nm |
| q | Self-locking |
| q | Renew |
| 22 - | Bush |
