–
| Place used oil collection and extraction unit -V.A.G 1782- below gearbox. |
WARNING |
–
| Remove screw plug for oil filler hole -arrow- using an Allen key (8 mm). |
Note t
| Use only an Allen key to unscrew screw plug (do not use hexagon key extension, 8 mm -3247-). |
t
| If access to screw plug is restricted, detach heat shield and, if necessary, remove drive shaft from gearbox and move clear to one side . |
l
| The oil level must be up to the bottom lip of the filler hole. |
–
| Drain off any excess gear oil or top up to proper level; specification → Chapter. |
Note The screw plug with seal must be renewed. |
–
| Tighten new screw plug for oil filler hole using hexagon key extension (8 mm) -3247-. |
|
|
|