audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing locking cable on vehicles with vehicle ID No. from 8E_8A 002700 onwards > < Checking and adjusting selector lever cable on vehicles with vehicle ID No. from 8E_8A 002700 onwards

A4 Mk2

Adjusting selector lever cable to basic setting on vehicles with vehicle ID No. from 8E_8A 002700 onwards
Adjusting selector lever cable to basic setting on vehicles with vehicle ID No. from 8E_8A 002700 onwards
Special tools and workshop equipment required
   
t  Socket and key -T40031-
Procedure
l  Tightening torques → Chapter „Exploded view - selector lever cable and locking cable on vehicles with vehicle ID No. from 8E_8A 002700 onwards“
–  Remove selector mechanism cover → Chapter.
–  Shift selector lever to position “D”.
  Note
  W00-1181
Before adjusting the selector lever cable to basic setting make sure that clamping bolt has been tightened. The clamping bolt can be accessed via the hole in the selector mechanism, when in position “D”. Use socket and key -T40031- to tighten clamping bolt.
–  Tighten clamping bolt in this position using hexagon key -T40031-.
–  Shift selector lever to position “P”.
  A37-10963
–  Unscrew support bracket from gearbox -arrows-.
  Note
t  Shown in illustration with gearbox support removed.
t  Make sure the selector lever is in position “P”.
  A37-10037
–  Push selector shaft lever -2- on gearbox towards rear as far as possible (in illustration: as far as possible to the right) until parking lock engages.
  Note
When the parking lock has engaged it should no longer be possible to rotate both front wheels in one direction.
–  Make sure that the selector lever cable -1- has not been bent or kinked and that it is not under tension.
  A37-10964
–  Bolt on the support bracket for selector lever cable -arrows-.
–  Adjust selector lever cable → Chapter „Checking and adjusting selector lever cable on vehicles with vehicle ID No. from 8E_8A 002700 onwards“.
  A37-10037

Removing and installing locking cable on vehicles with vehicle ID No. from 8E_8A 002700 onwards > < Checking and adjusting selector lever cable on vehicles with vehicle ID No. from 8E_8A 002700 onwards