audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Renewing O-ring on cover for final drive > < Removing and installing flange shaft (right-side)

A4 Mk2

Renewing oil seal for flange shaft (right-side)
   
Renewing oil seal for flange shaft (right-side)
Special tools and workshop equipment required
t  Drip tray -V.A.G 1306-
t  Oil seal extractor lever -VW 681-
t  Thrust piece -T10138-

Procedure
l  Gearbox in vehicle
  Note
t  General repair instructions → Chapter.
t  Rules for cleanliness when working on the automatic gearbox → Chapter.
–  Place drip tray -V.A.G 1306- under the gearbox.
–  Remove flange shaft (right-side) → Chapter.
   
–  Pull out flange shaft oil seal.
  A39-0033
–  Lubricate outer circumference of seal with gear oil
–  Drive in new oil seal onto stop (take care to keep oil seal straight).
l  Installation position: the open side of the seal should face the gearbox.
–  Pack space between sealing lip and dust lip half-full with sealing grease -G 052 128 A1-.
–  Install flange shaft (right-side) → Chapter.
–  Check oil level in front final drive → Chapter.
  A39-0381

Renewing O-ring on cover for final drive > < Removing and installing flange shaft (right-side)