Servicing ATF pipes, ATF cooler and additional ATF filter |
Note t
| Rules for cleanliness when working on the automatic gearbox → Chapter. |
t
| Before fitting a replacement gearbox, always blow through the ATF cooler and ATF pipes with compressed air (not more than 10 bar) → Chapter and renew the additional ATF filter. If the ATF which emerges during cleaning is very dirty, the pipes and ATF cooler must additionally be flushed out with clean ATF. |
t
| To install, first press ATF pipes onto gearbox or cooler by hand until they engage, then bolt on. |
Caution t
| All plugs inserted in ATF pipes and gearbox when dismantling must be removed. |
t
| If you forget to remove the plugs, the ATF cooling will be ineffective and the gearbox will be damaged. |
|
|
|
|