audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing gearbox > < Removing and installing locking cable (vehicles from VIN 8E_6A156500 onwards)

A4 Mk2

Adjusting locking cable (vehicles from VIN 8E_6A156500 onwards)
Adjusting locking cable (vehicles from VIN 8E_6A156500 onwards)
Special tools and workshop equipment required
   
t  Locking cable adjustment gauge -3352 A-
t  Safety goggles
  W00-0385
Preparation
  Note
The centre console does not have to be removed if the procedure described below is followed.
–  Using an angle grinder or similar, cut off the locking cable adjustment gauge -3352 A- at the rear end of the flat section -arrow-.
  WARNING
Wear safety goggles.
–  Order a new locking cable adjustment gauge as a replacement for subsequent use.
Procedure
–  Move steering wheel all the way down and towards driver's seat as far as possible.
–  Remove selector mechanism cover → Chapter.
–  Remove ashtray from centre console → General body repairs, interior; Rep. Gr.68.
–  Shift selector lever to position “P”.
  A37-0497
–  Slacken bolt -1-.
l  It should be possible to move support bracket -2- for locking cable by hand.
–  Insert locking cable adjustment gauge -3352 A- between pin on locking cable lever and locking cable eye.
–  Pull locking cable in direction of -arrow- and tighten bolt to 10 Nm.
–  Remove adjustment gauge.
–  Always check ignition key removal lock after adjusting locking cable → Chapter.
Tightening torque
  A37-0451
ComponentNm
Locking cable to cable support bracket10

   

Removing and installing gearbox > < Removing and installing locking cable (vehicles from VIN 8E_6A156500 onwards)