A4 Mk2
| Exploded view - Selector lever cable and locking cable (vehicles up to VIN 8E_6A156499) |
Note| t | Do not bend or kink the selector lever cable. |
| t | Before installing, lightly lubricate cable eye and ball socket with polycarbamide grease -G 052 142 A2-. |
| 1 - | Nut |
| q | 23 Nm |
| 2 - | Selector lever cable |
| q | Do not bend or kink, lightly grease cable eye and ball socket before installing. |
| q | Removing and installing → Chapter |
| q | Adjusting → Chapter |
| q | Selector lever cable must be renewed if rubber sleeve is damaged |
| q | When installing, make sure that rubber sleeve on gearbox end is not twisted |
| 3 - | Lock nuts |
| q | 13 Nm |
| 4 - | Rubber sleeve for selector lever cable |
| q | Press into selector mechanism cover (bottom). |
| 5 - | Retaining clip |
| 6 - | Ignition/starter switch |
| q | With ignition key removal lock |
| 7 - | Locking cable |
| q | For ignition key removal lock |
| q | Must not be kinked |
| q | Removing and installing → Chapter |
| q | Adjusting → Chapter |
| 8 - | Bolt |
| q | 9 Nm |
| 9 - | Clamping bolt |
| q | 13 Nm |
| q | For selector lever cable |
| q | Loosen 1 turn for adjusting, do NOT remove completely |
| 10 - | Pin |
| q | For selector lever cable |
| q | To remove selector lever cable, pull plastic securing spring on selector mechanism forwards slightly and push up pin just far enough to release cable. |
| 11 - | Retaining clip for selector lever cable |
| 12 - | Support bracket for selector lever cable |
| 13 - | Bolt |
| q | 23 Nm |
| 14 - | Bracket for selector lever cable |
