Contact corrosion can occur if non-approved fasteners are used on the vehicle (bolts, nuts, washers etc.). |
For this reason, only fasteners with a special surface coating are fitted. |
Rubber or plastic parts and adhesives also consist of non-conductive materials. |
If you are not sure whether used parts can be re-installed, always fit new parts → Parts catalogue. |
t
| Use only genuine spare parts: these have been fully tested and are compatible with aluminium. |
t
| We recommend the use of accessories approved by Audi. |
t
| Damage resulting from contact corrosion is not covered by the warranty. |
|
|
|