A4 Mk2
| Exploded view - removing and installing differential |
| l | Rear final drive removed |
| Refer to general repair instructions → Chapter. |
| Clamp rear final drive in assembly stand → Fig. |
| 1) | Adjustment work is required if these components are renewed → Chapter |
| 1 - | Breather sleeve |
| q | With rubber valve |
| q | Installation position → Fig. |
| 2 - | Rear final drive housing → Note |
| q | Removing and installing pinion shaft → Chapter |
| 3 - | Large tapered roller bearing outer race → Note |
| q | Removing and installing → Chapter |
| 4 - | Shim S1 |
| q | Note thickness |
| q | Table of adjustments → Chapter |
| 5 - | Cover for rear final drive → Note |
| q | With O-ring |
| q | Always renew O-ring |
| q | Lubricate O-ring with gear oil before installing |
| 6 - | Torx bolt, 25 Nm |
| 7 - | Oil seal |
| q | Renewing → Chapter |
| 8 - | Hexagon socket head bolt, 25 Nm |
| 9 - | Flange shaft |
| q | Removing and installing → Fig. |
| 10 - | Screw plug, 35 Nm |
| q | Checking gear oil in rear final drive → Chapter |
| q | Capacity and specification → Chapter |
| 11 - | Differential with crown wheel → Note |
| q | Dismantling and assembling → Chapter |
| 12 - | Oil drain plug, 35 Nm |
| 13 - | Bush |
| q | Holds magnet in position |
| q | Drive in onto stop |
| 14 - | Magnet |
| q | Always clean before re-installing |
| 15 - | Small tapered roller bearing outer race → Note |
| q | Removing and installing → Chapter |
| 16 - | Shim S2 |
| q | Note thickness |
| q | Table of adjustments → Chapter |
| 17 - | Oil seal |
| q | Renewing → Chapter |
| 18 - | Flange shaft |
| q | Removing and installing → Fig. |
| 19 - | Hexagon socket head bolt, 25 Nm |
| 20 - | Cover |
| q | Installing → Fig. |
|
|
|
|
|
|
|
|
