audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Dismantling and assembling clutch "C” > < Dismantling and assembling clutch "E”

A4 Mk2

Assembling body “II”
Assembling body “II”
   
–  Renew rectangular section seals -3- and O-ring -2- for input shaft on clutch “E”-item 1-.
–  Lightly lubricate rectangular section seals -3- and O-ring -2- with vaseline before installing. Use vaseline only. Other types of lubricant will cause the gearbox hydraulics to malfunction.
–  Make sure that rectangular section seals -3- are seated properly all round in groove on input shaft.
  A37-10312
–  Push clutch “A”-item 2- onto clutch “E”-item 1- as far as stop.
  A37-10313
–  Fit circlip -2- on input shaft -1-.
  A37-10295
–  Fit axial needle bearing -2- on clutch “A”-item 1-.
–  Fit clutch “B”-item 3- onto plate carrier of clutch “A” (lift and rotate slightly as required).
l  Make sure that all plates of clutch “B” mesh one after the other with the plate carrier of clutch “A”.
–  Lift clutch “B” a few millimetres and then let it drop to check that all the plates have meshed.
t  If you hear a metallic sound, all the plates have meshed.
t  If you only hear a muffled sound, some of the plates have not meshed.
  A37-10349
–  Fit shim -2- on clutch “B”-item 1-.
  A37-10283

Dismantling and assembling clutch "C” > < Dismantling and assembling clutch "E”