Audi Workshop Service and Repair Manuals > A4 Mk2 > Power transmission | Servicing automatic gearbox 01V, front-wheel drive and four-wheel drive | Automatic gearbox, gears, control | Performing servicing work with gearbox installed | Removing and installing gearbox input speed sender G182 - gearbox with hydraulic control type "E17”

Removing and installing gearbox input speed senderG182 - gearbox with hydraulic control type “E17”

Removing and installing gearbox input speed sender -G182- - gearbox with hydraulic control type “E17”

Note

t	On gearboxes with hydraulic control system type “E17”, the gearbox input speed sender -G182- is an inductive sender and is fixed to the underside of the valve body.

t	For allocation of hydraulic control system refer to technical data → Automatic gearbox 01V, front-wheel drive and four-wheel drive; Rep. Gr.00.

Removing

–	Remove valve body → Chapter.

–	Turn valve body over.

–	Unplug electrical connector at gearbox input speed sender -G182--item 1-.

Note

Ignore -item 1- and -item 2-.

–	Unscrew bolts and remove gearbox input speed sender -G182--item 1-.

Note

-Item 2- can be disregarded.

Installing

Installation is carried out in reverse sequence; note the following:

–	Fit gearbox input speed sender -G182--item 1- with spacer bushes -2- to valve body and tighten bolts.

l	Length of spacer bushes: 20 mm.

l	Installation position: the contacts of gearbox input speed sender -G182- point towards the centre of the valve body.

–	Install valve body → Chapter.

–	Fill up with ATF → Automatic gearbox 01V, front-wheel drive and four-wheel drive; Rep. Gr.37.

Tightening torque

Component	Nm
Gearbox input speed sender -G182- to valve body	7

Audi Workshop Service and Repair Manuals