A4 Mk2
| Sealing flanges and flywheel/dual-mass flywheel - exploded view of components |
Note| Servicing clutch → Rep. Gr.30 |
| 1 - | 90 Nm + 90° (1/4 turn) further |
| q | Renew |
| q | Do not lubricate with oil |
| q | Use counterhold tool -3415- when loosening and tightening → Chapter „Renewing crankshaft oil seal (pulley end)“ |
| 2 - | Crankshaft toothed belt sprocket |
| 3 - | 15 Nm |
| 4 - | Oil seal |
| q | Renewing → Chapter |
| q | Do not lubricate with oil |
| 5 - | Sealing flange (front) |
| q | Must be positioned on dowel sleeves |
| q | Install using sealant; sealant → Parts catalogue |
| q | Removing and installing → Chapter |
| 6 - | Cylinder block |
| 7 - | Securing bolt |
| q | Renew |
| q | Tightening torque for dual-mass flywheel → Anchor |
| q | Tightening torque for flywheel → Anchor |
| 8 - | Flywheel/dual-mass flywheel |
| q | Removing and installing dual-mass flywheel on vehicles with manual gearbox → Chapter |
| q | Removing and installing flywheel on vehicles with multitronic gearbox → Chapter |
| 9 - | Intermediate plate |
| q | Must be positioned on dowel sleeves |
| q | Do not damage/bend when assembling |
| q | Is fitted onto sealing flange → Fig. |
| 10 - | Sealing flange (rear) with oil seal |
| q | Renew only as complete unit |
| q | Removing and installing → Chapter |
|
|
